0

Your Cart is Empty

Useful Info - How to choose correct length of Mesh Band

How to choose correct length of Mesh Band

Mesh Style Watch Bands

Shark Mesh Band is not cuttable, length adjustment can only do on the buckle, therefore a proper “Length range” selection is very important.

This simple tutorial is a measurement guide, two measurements are required:

  1. your wrist circumference
  2. watch case size (from spring bar hole to hole)
  • Your wrist circumference

You can use a measuring tape or any soft tape eg. USB cable, wrap it around your wrist without slack, to find your wrist circumference in mm.

  • Watch case size (from spring bar hole to spring bar hole)

 

Use a flat ruler to measure the straight distance between spring bars hole to hole in mm.

Measurement Guide

Click the “Check your size” displayed on every Winghead SHARK Mesh item page, it will redirect you to our “Measurement Guide” page.

Simply enter the above data : Your wrist circumference & Watch case size

Press “ENTER“

Your best match “Length range” result will show up

1. How to measure your wrist circumference

2. How to measure your watch case size

Use a flat ruler to measure the straight distance between spring bar hole to spring bar hole as shown in mm.

Note this is your wrist Watch case size, enter this figure to Winghead Shark Mesh Calculator.

3. Apply data to Mesh Length Calculator

Enter the figures in the Measurement Guide Pages, your best match “Length range” result will show up

Back to Useful Info Page